Handpiece Connection; Air Hose Routing; System Power Up - Pace ST 40A Operation & Maintenance Manual

Set-Up

Handpiece Connection

8. Connect the handpiece connector plug into the Power Receptacle in the
following manner.
a) With the Connector Key end facing
the power source, turn the Locking
Ring fully counterclockwise .
b) Align the Connector Key with the
Receptacle Keyway.
c) Insert the connector into the Power
Receptacle.
d) Turn the Locking Ring fully
clockwise to secure in place.

Air Hose Routing

When using an Air Handpiece (e.g., SX-70
Sodr-X-Tractor) or a Tip-Evac Fume Extraction
System, route any associated air hose(s) through
the 2 Air Hose Feed Thru holes located on the
bottom of the power source.

System Power Up

9. Insert the female end of the power cord into the AC Power Receptacle at
the rear panel of the power source.
10. Plug the the prong end (male end) of the power cord into a 3 wire
grounded AC supply receptacle. The system is now ready for operation.
To insure operator safety, the AC supply receptacle must be checked for
proper grounding before initial operation.
11. Read the "Operation" section of this manual thoroughly before operating
the system.
8
CAUTION