Safety; Set-Up; System - Pace ST 40A Operation & Maintenance Manual

Safety

The following are safety precautions which personnel must understand and follow
when using or servicing this product.
1. SensaTemp handpiece heaters and installed tips are hot when the
handpiece is powered on. DO NOT touch either the heater or the tip.
Severe burns may result.
2. The enclosed SP Tip & Tool Stand has been designed specifically for use
with the Sodr-Pen (SP-1A & SP-2A) and houses the handpiece in a
manner which protects the user from accidental burns. Always store the
handpiece in the SP Tip & Tool Stand.
3. Always use this system in a well ventilated area. A fume extraction
system such as those available from PACE are highly recommended to
help protect personnel from solder flux fumes.
4. Exercise proper precautions when using materials (e.g., fluxes & solder
paste). Refer to the Material Safety Data Sheet (MSDS) supplied with each
material and follow to all safety precautions recommended by the
manufacturer.
5. POTENTIAL SHOCK HAZARD - Repair procedures on this product
should be performed by Qualified Service Personnel only. Line voltage
parts will be exposed when the equipment is disassembled. Service
personnel must avoid contact with these parts when troubleshooting the
power source.

Set-Up

System

Set up the ST 40A system using the following steps and associated drawings.
1. Store the shipping container(s) in a
convenient location. Reuse of these
containers will prevent damage if you
store or ship the system.
2. Place the Power Switch in the "OFF" or
"0" position.
3. Place 4 of the supplied Rubber Feet on
the base (bottom) of the power source.
Remove the paper backing and place in
corner indentations.
6