Table of Contents
Advertisement
Operation
Exiting Temperature Setback
Listed below are 2 different ways to exit Temperature Setback.
1. Press and release either Scroll Key (
method.
2. Method "1" is preferred but you can turn the Power Switch "OFF" (0)
and then back "ON" (1).
Set Tip Temperature and Tip Offset Constant values will be simultaneously restored.
Observe the Digital Readout as the Operating Tip Temperature stabilizes at the Set
Tip Temperature. For optimum performance, do not attempt to use the attached
handpiece until the Set Tip Temperature is achieved.
Auto Off Safety System
The Auto Off safety system of the ST 40A system removes power 30-120 minutes
(adjustable in Set-Up Mode) after entering Temperature Setback. This feature is
automatically enabled when Temperature Setback is enabled.
Operation
When the system has entered Temperature SetBack, an Auto Off timer within the
system circuitry will start running:
1. If any key is pressed during the selected time out period, the Auto Off
timer is reset.
2 The bottom line of the Digital Readout displays "X:XX to Auto OFF"
("X" = 0 thru 9), alerting the operator as to the length of time remaining
(in hours and minutes) before the system enters Auto Off.
3 At the end of the time out period, the system will enter Auto Off. Power
is removed and the Digital Readout will display "System is OFF Press
Any Key".
Exiting Auto Off
Auto Off can be exited; returning to normal operation by
1. Pressing any key
2. By turning the Power Switch OFF ("0") and then back ON ("1").
28
OR
or
). This is the preferred
Advertisement
Table of Contents
