Table of Contents
Advertisement
Quick Start - Basic Operation
Introduction
The ST 40A system is very easy to operate. As received from the factory, the system
can be quickly set up for use in standard soldering operations. Simply perform the
following Quick Start Procedure to begin system operation.
Quick Start Procedure
1. Insure that the Set-Up procedure has been performed; including the
Heater Burn In procedure. Check for the following:
a) Handpiece connection to the power source.
b) Proper tip installed in handpiece.
c) Power cord connection between house AC supply receptacle and the
power source.
2. Turn the Power Switch "On" ("1").
3. Press the Set Key.
16
S e t Te m p = O F F
P r e s s S E T t h e n
Advertisement
Table of Contents
