Sp Tip & Tool Stand - Pace ST 40A Operation & Maintenance Manual

SP Tip & Tool Stand
4. Place the 4 remaining Rubber
Feet on the bottom corners of the
enclosed SP Tip & Tool Stand.
5. The SP Tip & Tool Stand may be
used as "free standing" or may be
attached to either side of the
power source. Attach the stand
using the following procedure.
a) Insert the 2 enclosed Mounting
Screws (head first) into the 2
power source mounting slots
shown. Slide the screws toward
the rear of the power source.
b) Place the SP Tip & Tool Stand
beside the power source, inserting
ends of the 2 Mounting Screws
into the 2 SP Tip & Tool Stand
lower mounting holes shown.
c) Install a knurled Thumb Nut onto
the end of each Mounting Screw.
Tighten Thumb Nuts to secure the
stand in position.
6. Place the supplied sponge in the
SP Tip & Tool Stand using the
following procedure.
a) Remove the 2 small punched out
center portions of the sponge &
place into the sponge well of the
stand in the position shown.
b) Place the large sponge section into
the sponge well as shown.
c) Dampen the sponges with water.
7. Place the handpiece into the SP Tip &
Tool Stand.
Set-Up
7