Adjusting The Angle Of The Cubby; Handpiece Connection; System Power-Up - Pace HW 100 HeatWise Operation And Maintenance Manual

Stand has been mounted on the left of the power-source. To mount the Tool Stand on the right side
of the power-source, simply flip the Interlock over.
1. To attach the Tool Stand to the power-source:
a) Remove the two outside feet from the power source.
b) Remove the two outside feet from the Tool Stand.
c) Place the Interlock bracket over the base of the power source so the remaining feet
pass through large holes
d) Reinstall the removed power-source feet through the small holes in the Interlock.
e) Place Tool Stand on Interlock bracket and align remaining feet with large holes in
Interlock bracket
f) Reinstall removed Tool Stand feet through the small holes in Interlock bracket.
2. Place the handpiece into its Tip & Tool Stand.

Adjusting the Angle of the Cubby

The angle of the Handpiece Cubby may be adjusted by loosening the angle thumb screw slightly,
adjusting the cubby to the desired angle, and tightening the thumb screw.

Handpiece Connection

Connect the handpiece connector plug into the Power Receptacle in the following
manner.
1. Align guide on the connector with slot on power receptacle.
2. Insert connector into power receptacle.
3. Turn the connector housing clockwise to lock in place.
System Power Up
1. Insert the female end of the power cord into the AC Power
Receptacle on the rear panel of the power source.
2. Plug the prong end (male end) of the power cord into an appropriate 3 wire grounded AC
supply receptacle.
CAUTION: To insure operator and ESD/EOS safety, the AC power supply receptacle must be
checked for proper grounding before initial operation.
NOTE: Ensure that the system is placed in a well-ventilated area. Fume extraction equipment
is recommended
©2004 PACE Inc., Annapolis Junction, Maryland
All Rights Reserved
Thumb Screw
Page 6 of 17