Table of Contents
Advertisement
Handpiece Tips
Tip Installation
For maximum productivity and proper fit, install tips into your Sodr-Pen when the
heater is hot.
Hold the handpiece with the heater pointed up at an angle to prevent injury
to personnel.
1. Select the proper tip for your application. Refer to Table I or the PACE
Tip & Applications Catalog.
2. Install the selected tip in the following manner.
a) Hold the handpiece with the heater up at an angle (heater hot).
b) Insert the Tip all the way into the heater bore using the supplied Tip
Tool.
c) Gently tighten the heater Set Screw.
3. Recheck the tip Set Screw periodically to insure that it remains snug.
Periodically, clean the heater bore with a properly sized wire brush (3/16"
O.D. for SP-2A and 1/8" O.D. for SP-1A) to insure optimum heat transfer and
proper tip grounding.
14
CAUTION
NOTE
Advertisement
Table of Contents
