Heater Burn In - Pace ST 40A Operation & Maintenance Manual

Heater Burn In

To insure optimum performance and long life, new handpieces must undergo a burn
in procedure. A Red tag is attached to each handpiece and with replacement heater
assemblies which describes the proper procedure. The ST 40A system however,
has a Burn In feature which, when activated will burn in the heater in a similar
manner as is described on the tag. Use this feature when setting up a new ST 40A
system (burn in all handpieces) or when replacing a handpiece heater assembly.
As received from the factory, the Set Temperature will be "OFF". The system
power source must have an entered Set Temperature before using this
feature. If the Set Temperature is "OFF", enter a temperature at this time (see
Operation section of this manual).
Ensure that the system is placed in a well-ventilated area. Smoke will be
emitted from the heater assembly during the burn in cycle.
Use the following instructions to perform the Heater Burn In procedure.
1. Place the Power Switch in the "OFF" (0) position.
2. Ensure that the handpiece is connected to the system power source.
3. Some handpieces heater assemblies are shipped with a plastic cap
installed on the end of the heater assembly. If this cap is present, remove
the cap and discard. The cap is used for shipping purposes only.
4. Press and hold the Set and Scroll
Up ( ) keys together.
5. Place the Power Switch in the
"ON" (I) position. The Digital
Readout will display "VERSION
X.X".
6. Immediately release the Set and
Scroll Up ( ) keys.
7. Press the Set Key to enter the
Burn In Mode.
NOTE
Set-Up
9