Handpiece Connection; System Power Up - Pace ST 65 Operation & Maintenance Manual

b) Connect the free end of a 1 inch (2.5cm) length of air hose with an
installed female quick connect hose mount fitting (P/N 1259-0086) to
the FLOW IN side of the VisiFilter Assembly.
c) The 137cm (54 inch) length of air hose can now be easily moved
between the VisiFilter Assembly and the Controllable Pressure Port.
The VisiFilter assembly remains connected to the Vacuum Port.
4. Additional fittings may also be added to the hose connection at the rear of
each air handpiece to ease changing of handpieces.
When removing any air hose, turn and pull. Do not attempt to pull hose directly off.
Damage to or breakage of fitting or VisiFilter may occur. Use your Sodr-X-Tractor with
a clean VisiFilter element. Otherwise a deterioration in performance or damage to the
unit may occur.

Handpiece Connection

Connect the handpiece connector plug into the Power Receptacle in the following
manner.
1. Align guide on connector with slot on
power receptacle.
2. Insert connector into power receptacle.
3. Turn the connector housing clockwise to
lock in place.

System Power Up

1. Insert the female end of the power cord into the AC Power Receptacle at the
rear panel of the power source.
2. Plug the prong end (male end) of the power cord into a 3 wire grounded AC
supply receptacle. The system is now ready for operation.
To ensure operator safety, the AC supply receptacle must be checked for proper
grounding before initial operation.
3. Read this manual and all other included manuals thoroughly before
operating the system.
NOTE
CAUTION
Set-Up
15