System Set-Up; Mounting Options; Tip & Tool Stand; Handpiece Connection - Pace ST 25 Operation And Maintenance Manual

System Set-Up

Set up the ST 25 or ST 35 system using the following steps and associated drawings.
1. Store the shipping container in a convenient location. Reuse of these
containers will prevent damage if you store or ship your system.
2. Place the Power Switch in the "OFF" or "0" position.

Mounting Options

The ST 25 and ST 35 can be placed directly on a work bench and can be stacked if more than one
system is used. The ST 35 can also be mounted under a workbench or shelf to conserve space. To
mount the system in this way:
1. Mount the bracket in the desired location (fasteners not
supplied).
2. Insert the 2 Mounting Screws (head first) into the power
source mounting slots.
3. Place the washers over the screws.
4. Fit the power source between the bracket's support arms
and place the screws into the slots on the support arms.
5. Place the nut on the screw and tighten by hand.
6. Angle the power source so the operator can see the display
easily.
7. Tighten the nuts with a wrench or pliers.
Tip & Tool Stand
The Tip & Tool Stand can be mounted to the power source. If the system will be placed on the
workbench, this is recommended. If the ST 35 is to be mounted under the workbench or shelf, the
Tip & Tool Stand should not be mounted to the power source.
1. To attach the stand to the power source:
a) Insert the 2 Mounting Screws (head first) into the power
source mounting slots (plastic case shown). Slide the
screws toward rear of the power source.
b) Place the Tip & Tool Stand beside the power source.
Insert ends of the 2 Mounting Screws into the 2 Tip &
Tool Stand mounting holes as shown.
c) Install a Thumb Nut onto the end of each Mounting
Screw and tighten Thumb Nuts.
2. Place the handpiece into its Tip & Tool Stand.

Handpiece Connection

Connect the handpiece connector plug into the Power Receptacle in
the following manner.
1. Align guide on connector with slot on power receptacle.
2. Insert connector into power receptacle.
3. Turn the connector housing clockwise to lock in place.
System Power Up
1. Insert the female end of the power cord into the AC Power Receptacle on the rear panel of
the power source.
©2001 PACE Inc., Laurel, Maryland
All Rights Reserved
Page 8 of 14