Xilinx Virtex-7 FPGA VC7203 Getting Started Manual page 18

2. In the Hardware window, right-click XC7VX485T_1 and select Refresh Device
(Figure 1-14).
If the FPGA was not programmed using the SD card, provide both the programming and
Note:
the probes files, and then select Program Device.
X-Ref Target - Figure 1-14
VC7203 IBERT Getting Started Guide
UG847 (Vivado Design Suite v2015.1) April 27, 2015
Chapter 1: VC7203 IBERT Getting Started Guide
Figure 1-14: Program/Refresh Device
www.xilinx.com 18
Send Feedback