Xilinx Virtex-7 FPGA VC7203 Getting Started Manual page 10

Attach the GTX Quad Connector
Before connecting the BullsEye cable assembly to the board, firmly secure the blue
elastomer seal provided with the cable assembly to the bottom of the connector housing if
it is not already inserted (see
Figure 1-4
Note:
X-Ref Target - Figure 1-4
Attach the Samtec BullsEye connector to GTX Quad 115
indexing pins on the bottom of the connector with the guide holes on the board. Hold the
connector flush with the board and fasten it by tightening the two captive screws.
X-Ref Target - Figure 1-5
VC7203 IBERT Getting Started Guide
UG847 (Vivado Design Suite v2015.1) April 27, 2015
Figure 1-4).
is for reference only and might not reflect the current version of the connector.
Figure 1-4: BullsEye Connector with Elastomer Seal
Figure 1-5: BullsEye Connector Attached to Quad 115
www.xilinx.com
Chapter 1: VC7203 IBERT Getting Started Guide
(Figure 1-5), aligning the two
10
Send Feedback