Visibility From Operator's Seat - Komatsu D475A-5E0 Operation & Maintenance Manual

FOREWORD
INTRODUCTION

VISIBILITY FROM OPERATOR'S SEAT

The visibility standards (ISO 5006) for this machine require a view shown in the following figure.
PROXIMITY VISIBILITY
The visibility of this machine in the area 1 m (3 ft 3 in) from the outside surface of the machine at a height of 1.5 m
(4 ft 11 in) is shown in the following figure. The hatched area (A) shows the area where the view is blocked by part
of the machine when mirrors or other aids to visibility are installed as standard. Be fully aware that there are places
that cannot be seen when operating the machine.
12M CIRCUMFERENCE VISIBILITY
The visibility at a radius of 12 m (39 ft 4 in) from the machine is as shown in the diagram below. The hatched areas
(B) show the areas where the view is blocked when mirrors or other aids to visibility are installed as standard. Be
fully aware that there are places that cannot be seen when operating the machine.
1 - 5