Komatsu D475A-5E0 Operation & Maintenance Manual page 368

ATTACHMENTS, OPTIONS
KOMTRAX Plus AND COMMUNICATIONS TERMINAL INSTALLED
The KOMTRAX Plus communications terminal is a wireless device using radio waves, so it is necessary to obtain
authorization and conform to the laws of the country or territory where the machine equipped with the KOMTRAX
Plus communications terminal is being used. Always contact your Komatsu distributor before selling or exporting
any machine equipped with the KOMTRAX Plus communications terminal.
When selling or exporting the machine or at other times when your Komatsu distributor considers it necessary,
it may be necessary for your Komatsu distributor to remove the KOMTRAX Plus communications terminal or to
perform action to stop communications.
If you do not obey the above precautions, neither Komatsu nor your Komatsu distributor can take any
responsibility for any problem that is caused or for any loss that results.
BASIC PRECAUTIONS
Never disassemble, repair, modify, or move the KOMTRAX Plus, communications terminal, antenna, or cables. This may cause
failure or fire on the KOMTRAX Plus communications terminal or the machine itself. (Your Komatsu distributor will perform
removal and installation of the KOMTRAX Plus and communications terminal.)
Do not allow cables or cords to become caught; do not damage or pull cables or cords by force. Short circuits or disconnected
wires may cause failure or fire on the KOMTRAX Plus communications terminal or the machine itself.
Near the blasting jobsite, there may be a danger of unexpected explosion due to use of interactive wireless communication
device of KOMTRAX Plus and resulting serious personal injury or death. Make sure to operate the machine away from the
blasting jobsite. If you have to operate the machine within 12 m (39 ft 4 in) from the blasting jobsite or the remote blasting
device, ask your Komatsu distributor to disconnect power source cable of KOMTRAX Plus in advance.
If there are any restriction or law of the territory or country where the machine equipped with this device is used, such
restriction or law has a priority than this warning.
NOTICE
Contact your Komatsu distributor before installing a top guard or other attachment that covers the antenna.
Be careful not to get water on the communications terminal or wiring.
REMARK
The communications terminal uses wireless communications, so it cannot be used inside tunnels, underground,
inside buildings, or in mountain areas where radio waves cannot be received. Even when the machine is outside,
it cannot be used in areas where the radio signal is weak or in areas outside the wireless communication service
area.
There is absolutely no need to inspect or operate the KOMTRAX Plus or communications terminal, but if any
abnormality is found, contact your Komatsu distributor.
HANDLING MACHINES EQUIPPED WITH KOMTRAX Plus
WARNING
6 - 29