Check, Clean Fuel Strainer - Komatsu D475A-5E0 Operation & Maintenance Manual

MAINTENANCE MAINTENANCE
7. Loosen bolt (7), then divide into strainer (5) and magnet (6).
Tightening torque of bolt (7): 46 to 59 Nm (4.7 to 5.9 kgm, 34
8. Remove all dirt from strainer, then wash in clean diesel oil or
flushing oil.
Clean the case interior and the removed parts.
9. Install the strainers to their original position.
10. After installing, replace the element in the power train oil filter.
For details, see "EVERY 500 HOURS SERVICE (PAGE
4-68)".
11. Refill the specified quantity of oil through oil filler port (F).
12. After adding oil, check that the oil is at the specified level. For
details, see "CHECK OIL LEVEL IN POWER TRAIN CASE,
ADD OIL (PAGE 3-94)".

CHECK, CLEAN FUEL STRAINER

1. Tighten valve (1).
2. Remove cap (2), and wash the strainer and strainer case.
The strainer forms one unit with the cap.
3. After checking and cleaning, set the strainer in the case, then
tighten cap (2).
4. After installing, open valve (1).
to 43 lbft)
SERVICE PROCEDURE SERVICE PROCEDURE
4 - 75