OPERATION
OPERATION
3. Operate parking brake lever (4) to LOCK (L) position.
4. Operate blade control lever (5) and ripper control lever (6) to
LOWER (c) position to lower the blade and ripper to the
ground.
5. Operate blade control lever (5) and ripper control lever (6) to
HOLD (b) position.
6. Operate blade control lever (5) and work equipment lock lever
(7) of ripper control lever (6) to LOCK (L) position.
CHECK AFTER STOPPING ENGINE
1. Walk around the machine and check the work equipment, machine exterior, and undercarriage, also check for
any leakage of oil or coolant. If any problems are found, repair them.
2. Fill the fuel tank.
3. Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard.
4. Remove any mud affixed to the undercarriage.
3 - 142
OPERATION
OPERATION