Table of Contents
Advertisement
MINING SPECIFICATION MACHINE
EVERY 2000 HOURS SERVICE
CHANGE OIL IN HYDRAULIC TANK, REPLACE HYDRAULIC OIL FILTER ELEMENT, CLEAN
HYDRAULIC TANK
The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before changing
the oil.
When removing oil filler cap (F), turn it slowly to release the internal pressure, then remove it carefully.
Refill capacity: 170 liters (44.91 US gal)
1. Lower the blade and ripper to the ground, and stop the engine.
Turn the cap of oil filler port (F) slowly to release the internal
pressure, then remove the cap.
2. Remove drain plug (1) at the bottom of the tank and loosen
drain valve (2). After draining the oil, tighten drain plug (1) and
drain valve (2). When loosening drain valve (1), be careful not
to get oil on yourself.
3. Remove bolts (3), then remove cover (4), and take out element
(5).
4. Clean the inside of case and removed parts and install a new
element.
6 - 58
WARNING
ATTACHMENTS, OPTIONS
Advertisement
Chapters
Table of Contents
