Komatsu D475A-5E0 Operation & Maintenance Manual page 377

MINING SPECIFICATION MACHINE
Fuse box (4)
Fuse
NO.
capacity
(1) 10 A Car radio, cigarette lighter, room lamp
(2) 10 A Rear wiper
(3) 10 A R.H. wiper
(4) 10 A Front wiper
(5) 10 A L.H. wiper
(6) 20 A Additional front lamp
(7) 20 A Additional rear lamp, revolving lamp
(8) - Spare
(9) - Spare
(10) 10 A Radio memory
CIRCUIT BREAKER FOR MAIN POWER SUPPLY
If the starting motor does not move when the starting switch is
turned to the START position, open the battery box and check
circuit breakers (A) to (G).
If there is a surge of current, the circuit breaker shuts off the
circuit to protect the electrical components and wiring from
damage.
Turn the starting switch to OFF position and reset the circuit breaker.
When resetting the electrical circuit after it has been shut off, press the reset button 5 to 10 minutes after the circuit
has been shut off. When the electrical circuit has been shut off, the operation of the reset button is heavier than
when the circuit is normal. The height of the reset button is the same, regardless of whether the circuit has been
shut off or has been reset, so make note of the effort of the reset button when resetting the circuit.
Do not keep the circuit breaker reset button longer than necessary.
If the starting motor does not work even when the circuit breaker has been reset, contact your Komatsu
distributor.
REMARK
The capacities for circuit breakers (A) to (G) are as follows.
(A): 30 A (permanent power supply for cab)
(B): 105 A (general power supply)
(C): 105 A (electrical intake air heater)
(D): 105 A (electrical intake air heater)
(E): 30 A (spare for optional equipment)
(F): 30 A (permanent power supply for engine controller)
(G): 30 A (permanent power supply for engine controller)
6 - 38
Name of circuit
ATTACHMENTS, OPTIONS