Removal Of Cab - Komatsu D475A-5E0 Operation & Maintenance Manual

OPERATION

REMOVAL OF CAB

(Machine equipped with cab)
If it is necessary to remove the cab for transporting, disconnect the washer hoses, cab power source, and washer
motor wiring from the socket before removing the cab.
1. Remove the cab wiring harness connector and washer hose.
1) Pull the grommet portion in towards the cab from the hole
in the machine cover, then remove.
2) Disconnect 4 washer hoses and the wiring (single wires x
2, 4-pin plug x 1) from the socket.
After removing, cover the washer hoses with a vinyl bag to prevent any dirt or dust from entering.
Before removing the cab, measure the clearance between the cab and each lever (joystick (steering, directional
and gear shift lever), etc.). Note the measurements to use as a standard when installing the cab again.
No. Name
Washer
(1)
tube
Power source
(2)
of cab
(3) 4 pole connector For washer motor
Content
Red : Right door
Blue : Left door
Black : Rear window
No color : Front window
5R : ACC power source
of cab
2R : Backup power source
TRANSPORTATION
3 - 169