ATTACHMENTS, OPTIONS
ATTACHMENTS, OPTIONS
(5) Ripper tilt cylinder bottom pin (2 places)
(6) Ripper lift cylinder bottom pin (2 places)
(7) Ripper tilt cylinder rod end pin (2 places)
(8) Ripper lift cylinder rod end pin (2 places)
(9) Ripper arm pin (front) (2 places)
(10)Ripper arm pin (rear) (2 places)
The illustration on the right shows Giant Ripper (if equipped).
(11) Equalizer bar side shaft (2 places)
(12) Suspension (equalizer bar center shaft) (1 place)
1. Add grease to the suspension (equalizer bar center shaft)
through the grease fitting on the right side of the engine room
(marked with an arrow).
2. Pump the greasing lever up and down 3 to 5 times.
MINING SPECIFICATION MACHINE
MINING SPECIFICATION MACHINE
6 - 51