Table of Contents
Advertisement
MAINTENANCE
CHECK OIL LEVEL IN DAMPER CASE, ADD OIL
1. Open the engine side cover on the right side of the machine.
2. Remove dipstick (G) and wipe the oil off with a cloth.
3. Fully insert dipstick (G) into dipstick pipe, then remove it.
4. The oil should be between H and L marks on dipstick (G). If the
oil is below L mark, add oil through the dipstick insertion port.
5. If the oil is above H mark, open inspection cover (2) in the
center of the bottom face of the power train case, drain the
excess oil from engine damper drain plug (P) (this can be seen
towards the front of the machine from the inspection window),
then check the oil level again.
REMARK
Check the oil level while the engine is stopped.
If the machine is inclined, set it in a level position before checking the oil level.
SERVICE PROCEDURE
4 - 67
Advertisement
Chapters
Table of Contents
