Table of Contents
Advertisement
Reset fan operating time
The actual operating hours of the fan in the power unit is displayed.
After a fan replacement, the operating hours counter for monitoring the fan operating time
must be reset.
6.6.5.2
Device commissioning
Device commissioning
In this menu, you can enter the device commissioning status directly. This is the only way
that you can reset parameters to the factory setting for example.
6.6.5.3
Drive diagnostics
Curve recorder
The curve recorder provides a slow trace function, which monitors a signal trend.
A signal selected via a parameter is shown in the form of a curve.
Figure 6-19
The curve recorder-relevant settings are changed by pressing the F5 key or via the
"Commissioning / Service – AOP settings - Curve recorder-relevant settings" menu.
The value of the parameter selected in the curve recorder-relevant settings is output on the
display in addition to the curve and updated every 0.5 ... 24.5 seconds (parameterizable).
With a slowly running time basis (as of 20 minutes/figure), the time basis value flashes in the
header in the 1 s-cycle alternately with the text "slow X".
Assignment of the function keys F1 to F5 is not normally displayed so that the space can be
fully utilized to display the curve. Pressing a function key shows the key assignments. If no
further key is pressed within 5 seconds, the labeling will disappear again.
Enclosed Drives
Operating Instructions, 12/2018, A5E36652151A
Curve recorder
6.6 Control via the operator panel
Operation
297
Advertisement
Table of Contents
