AT commands
PT (PWM Output Timeout)
Specifies how long both PWM outputs (P0, P1) output a given PWM signal before it reverts to zero. If
set to 0, there is no timeout. This timeout only affects these pins when they are configured as PWM
output.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0xFF
Command mode options
The following commands are Command mode option commands.
CC (Command Sequence Character)
Sets or displays the ASCII sequence character to use for entering Command mode. Repeating the CC
character three times causes the XLR PRO to enter Command mode. The device responds with OK\r
when Command mode is successfully entered. The following commands are related to CC:
Use
GT (Guard Times)
n
command sequence—to guard against inadvertently entering Command mode.
Use
CT (Command Mode Timeout)
n
Use
CN (Exit Command mode)
n
Parameter range
0 - 0xFF
Default
0x2B (the ASCII plus character: +)
CN (Exit Command mode)
Exits Command mode and returns the XLR PRO to Idle mode.
Parameter range
N/A
Default
N/A
CT (Command Mode Timeout)
Sets or displays the Command mode timeout parameter. If a device does not receive any valid
commands within this time period, it returns to Idle mode from Command mode.
Parameter range
2 - 0x1770 (x 100 ms)
XLR PRO Radio Frequency (RF) Module User Guide
to define a guard time—the amount of time before and after entering a
to define the timeout for Command mode.
to immediately exit Command mode and return to Idle mode.
Command mode options
76