T9 Command; Q0 Command; Q1 Command; Q2 Command - Digi XBee3 802.15.4 User Manual

AT commands

T9 command

Specifies how long pin
0, there is no timeout.
Parameter range
0 - 0xFF
Default
0

Q0 command

Specifies how long pin P0 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0xFF
Default
0

Q1 command

Specifies how long pin P1 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0xFF
Default
0

Q2 command

Specifies how long pin P2 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0xFF
Default
0
PT (PWM Output Timeout)
Specifies how long both PWM outputs (P0, P1) output a given PWM signal before it reverts to the
configured value (M0/M1). If set to 0, there is no timeout. This timeout only affects these pins when
they are configured as PWM output.
Digi XBee3® 802.15.4 RF Module User Guide
D9 command holds a given value before it reverts to configured value. If set to
I/O line passing commands
122