Ised (Innovation, Science And Economic Development Canada) Certification; Rf Exposure; Ic Labeling Requirements; Transmitters With Detachable Antennas - Digi XLR PRO User Manual

Safety notices and certifications
This equipment is approved for mobile and base station transmitting devices only.
Antenna(s) used for this transmitter must be installed to provide a separation distance
of at least 25 cm (or 10 inches) from all persons and must not be co-located or operating
in conjunction with any other antenna or transmitter
ISED (Innovation, Science and Economic Development Canada)
certification
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

RF exposure

CAUTION: This equipment is approved for mobile and base station transmitting devices
only. Antenna(s) used for this transmitter must be installed to provide a separation
distance of at least 25 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.
ATTENTION: Cet équipement est approuvé pour la mobile et la station base dispositifs
d'émission seulement. Antenne(s) utilisé pour cet émetteur doit être installé pour fournir
une distance de séparation d'au moins 25 cm à partir de toutes les personnes et ne doit
pas être situé ou fonctionner en conjonction avec tout autre antenne ou émetteur.

IC labeling requirements

Labeling requirements for Industry Canada are similar to those of the FCC. A clearly visible label on
the outside of the final product enclosure must display the following text.
IC required text
Contains IC:1846A-XLRP
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B-
Unintentional Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada
accepts FCC test report or CISPR 22 test report for compliance with ICES-003.

Transmitters with detachable antennas

This radio transmitter (IC: 1846A-XLRP) has been approved by Industry Canada to operate with the
antenna types listed in
impedance for each antenna type indicated. Antenna types not included in this list, having a gain
greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.
Le présent émetteur radio (IC: 1846A-XLRP) a été approuvé par Industrie Canada pour fonctionner
avec les types d'antenne énumérés ci?dessous et ayant un gain admissible maximal et l'impédance
requise pour chaque type d'antenne. Les types d'antenne non inclus dans cette liste, ou dont le gain
est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur.
XLR PRO Radio Frequency (RF) Module User Guide

ISED (Innovation, Science and Economic Development Canada) certification

Antennas with the maximum permissible gain and required antenna
130