T9 (D9 Timeout); Q0 (P0 Timeout); Q1 (P1 Timeout); Q2 (P2 Timeout) - Digi DigiMesh XBee S2C User Manual

AT commands

T9 (D9 Timeout)

Specifies how long pin D9 holds a given value (due to I/O line passing) before it reverts to configured
value. If set to 0, there is no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

Q0 (P0 Timeout)

Specifies how long pin P0 holds a given value (due to I/O line passing) before it reverts to configured
value. If set to 0, there is no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

Q1 (P1 Timeout)

Specifies how long pin P1 holds a given value (due to I/O line passing) before it reverts to configured
value. If set to 0, there is no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

Q2 (P2 Timeout)

Specifies how long pin P2 holds a given value (due to I/O line passing) before it reverts to configured
value. If set to 0, there is no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

PT (PWM Output Timeout)

Specifies how long both PWM outputs (P0, P1) output a given PWM signal (due to I/O line
passing) before it reverts to the configured value (M0/M1). If set to 0, there is no timeout. This timeout
only affects these pins when they are configured as PWM output.
XBee S2C DigiMesh 2.4 User Guide
I/O line passing commands
105