Q2 (P2 Timeout); Q3 (P3 Timeout); Q4 (P4 Timeout); Pwm Output Timeout) - Digi XBee SX 868 User Manual

AT commands
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

Q2 (P2 Timeout)

This command applies to the XBee SX 868 RF Module.
Specifies how long pin P2 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

Q3 (P3 Timeout)

This command applies to the XBee SX 868 RF Module.
Specifies how long pin P3 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

Q4 (P4 Timeout)

This command applies to the XBee SX 868 RF Module.
Specifies how long pin P4 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0
PT (PWM Output Timeout)
This command applies to the XBee SX 868 RF Module.
Specifies how long both PWM outputs (P0, P1) output a given PWM signal before it reverts to zero. If
set to 0, there is no timeout. This timeout only affects these pins when they are configured as PWM
output.
XBee® SX 868 RF Module User Guide
I/O line passing commands
151