Addressing Discovery And Configuration Commands; Dn (Discover Node); Nd (Network Discover) - Digi XLR PRO User Manual

AT commands
Sets or displays the application layer source endpoint value used for data transmissions.
This command only affects outgoing transmissions in transparent mode (AP=0).
0xE8 is the Digi data endpoint used for outgoing data transmissions.
0xE6 is the Digi device object endpoint used for configuration and commands.
Parameter range
Value
0xE6
0xE8
Default
0xE8

Addressing discovery and configuration commands

DN (Discover Node)

Resolves an NI (Node identifier) string to a physical address (case sensitive).
When DN is sent in Command mode:
When a destination address is discovered, the device:
1. Sets DL (Destination Address Low)
the matching string.
2. Returns OK<CR>.
3. Exits command mode to allow immediate communications.
For API mode:
When a destination address is discovered:
Receiving device returns 0xFFFE and 64-bit extended addresses in an API command response
n
frame.
Errors
If there is no response after the number of milliseconds set by the
parameter or a parameter is not specified (left blank), the command is terminated and an ERROR
message is returned. When an ERROR is returned, command mode is not exited.
Parameter range
A string of case-sensitive ASCII printable characters from 1 to 20 bytes in length. The string cannot
start with the space character. A carriage return or a comma automatically ends the command.
Default
N/A

ND (Network Discover)

Discovers and reports all devices found in the network.
XLR PRO Radio Frequency (RF) Module User Guide
Description
Digi device endpoint
Digi data endpoint
and DH to the extended 64-bit address of the device with

Addressing discovery and configuration commands

N? (Network Discovery Timeout)
53