Table of Contents
Advertisement
AT commands
Addressing discovery/configuration commands
AG (Aggregator Support)
The AG command sends a broadcast through the network that has the following effects on nodes that
receive the broadcast:
The receiving node establishes a DigiMesh route back to the originating node, if there is space
n
in the routing table.
The DH and DL of the receiving node update to the address of the originating node if the AG
n
parameter matches the current DH/DL of the receiving node.
API-enabled devices with updated DH and DL send an Aggregate Addressing Update frame
n
(0x8E) out the serial port.
Note
The AG command is only available on products that support DigiMesh.
Parameter range
Any 64-bit address
Default
N/A
DN (Discover Node)
Resolves an NI (Node identifier) string to a physical address (case sensitive).
The following events occur after DN discovers the destination node:
When DN is sent in Command mode:
1. The device sets DL and DH to the extended (64-bit) address of the device with the matching NI
string.
2. The receiving device returns OK (or ERROR).
3. The device exits Command mode to allow for immediate communication. If an ERROR is
received, then Command mode does not exit.
When DN is sent as a local AT Command API frame (0x08):
1. The receiving device returns 0xFFFE followed by its 64-bit extended addresses in a
Command Response frame -
2. If there is no response from a module within (NT * 100) milliseconds or you do not specify a
parameter (by leaving it blank), the receiving device returns an ERROR message.
Parameter range
20-byte ASCII string
Default
N/A
XBee®/XBee-PRO SX RF Module User Guide
Addressing discovery/configuration commands
0x97.
Remote
78
Advertisement
Table of Contents
