Ci (Cluster Id); De Command; Se Command; Addressing Discovery/Configuration Commands - Digi XBee SX 868 User Manual

AT commands
Default
0x0
0

CI (Cluster ID)

The application layer cluster ID value. The device uses this value as the cluster ID for all data
transmissions.
Parameter range
0 - 0xFFFF
Default
0x11

DE command

Sets or displays the application layer destination ID value. The value is used as the destination
endpoint for all data transmissions. The default value (0xE8) is the Digi data endpoint.
Parameter range
0 - 0xFF
Default
0xE8

SE command

Sets or displays the application layer source endpoint value. The value is used as the source endpoint
for all data transmissions. The default value (0xE8) is the Digi data endpoint.
Sets or displays the application layer source endpoint value used for data transmissions.
This command only affects outgoing transmissions in transparent mode (AP=0).
0xE8 is the Digi data endpoint used for outgoing data transmissions.
0xE6 is the Digi device object endpoint used for configuration and commands.
Parameter range
0 - 0xFF
Default
0xE8

Addressing discovery/configuration commands

AG (Aggregator Support)

The AG command sends a broadcast through the network that has the following effects on nodes that
receive the broadcast:
XBee® SX 868 RF Module User Guide
Addressing discovery/configuration commands
102