Table of Contents
Advertisement
Approved antennas
XBee ZNet 2.5 RF Module
The following antennas are approved for use with the embedded XBee ZNet 2.5 RF Module:
•
Dipole (2.1 dBi, Omni-directional, Articulated RPSMA, Digi part number A24-HABSM)
•
Chip Antenna (-1.5 dBi)
•
Attached Monopole Whip (1.5 dBi)
•
Integral PCB Antenna (-0.5 dBi).
XBee-PRO ZNet 2.5 RF Module
The following antennas are approved for use with the embedded XBee ZNet 2.5 RF Module:
•
Dipole (2.1 dBi, Omni-directional, Articulated RPSMA, Digi part number A24-HABSM)
•
Chip Antenna (-1.5 dBi)
•
Attached Monopole Whip (1.5 dBi)
•
Integral PCB Antenna (-0.5 dBi).
Canada (IC)
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Labeling requirements
Labeling requirements for Industry Canada are similar to those of the FCC. A clearly visible label on
the outside of the final product enclosure must display the following text:
Contains Model XBee ZNet 2.5 Radio, IC: 4214A-XBEE2
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15,Sub. B -
Unintentional Radiators. ICES-003 is the same as FCC Part 15 Sub. B and IndustryCanada accepts FCC
test report or CISPR 22 test report for compliance with ICES-003.
If it contains an XBee PRO ZNet 2.5 OEM Module, the clearly visible label on the outside of the final
product enclosure must display the following text:
Contains Model XBee PRO ZNet 2.5 Radio, IC: 1846A-XBEEPRO2
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -
Unintentional Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts FCC
test report or CISPR 22 test report for compliance with ICES-003.
XBee ZNet 2.5 / XBee PRO Znet 2.5 OEM RF Modules Product Manual
OEM labeling requirements
104
Advertisement
Table of Contents
