Ised (Innovation, Science And Economic Development Canada); Labeling Requirements; For Xbee 3; Rf Exposure - Digi XBee 3 Hardware Reference Manual

Regulatory information

ISED (Innovation, Science and Economic Development Canada)

Labeling requirements

Labeling requirements for Industry Canada are similar to those of the FCC. A clearly visible label on
the outside of the final product enclosure must display the following text.

For XBee 3

Contains Model XBEE3, IC: 1846A-XBEE3
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -
Unintentional Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts
FCC test report or CISPR 22 test report for compliance with ICES-003.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

RF Exposure

CAUTION! This equipment is approved for mobile and base station transmitting devices only.
Antenna(s) used for this transmitter must be installed to provide a separation distance of at
least 20 cm from all persons and must not be co-located or operating in conjunction with any
other antenna or transmitter.
ATTENTION! Cet équipement est approuvé pour la mobile et la station base dispositifs
d'émission seulement. Antenne(s) utilisé pour cet émetteur doit être installé pour fournir
une distance de séparation d'au moins 20 cm à partir de toutes les personnes et ne doit
pas être situé ou fonctionner en conjonction avec tout autre antenne ou émetteur.
XBee 3 USB Adapter
The XBee 3 USB Adapter integrates an XBee 3 RF Module into its hardware. Special SAR testing was
undertaken for the XBee 3 USB Adapter product to ensure it met IC standards. It is approved as a
portable application.
Transmitters with Detachable Antennas
This radio transmitter (IC: 1846A-XBEE3) has been approved by Industry Canada to operate with the
antenna types listed in
required antenna impedance for each antenna type indicated. Antenna types not included in this list,
having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use
with this device.
Le présent émetteur radio (IC: 1846A-XBEE3) a été approuvé par Industrie Canada pour fonctionner
avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal et l'impédance
Digi XBee® 3 RF Module Hardware Reference Manual

ISED (Innovation, Science and Economic Development Canada)

FCC-approved antennas (2.4 GHz) with the maximum permissible gain and
53