Ic (Industry Canada) Certification; Ic Labeling Requirements - Digi XLR PRO User Manual

Fixed Base Station and Mobile Applications
Digi RF Modules are pre-FCC approved for use in fixed base station and mobile
applications. When the antenna is mounted at least 20cm (8") from nearby persons, the
application is considered a mobile application.
Portable Applications and SAR Testing
If the module will be used at distances closer than 20cm to all persons, the device may be
required to undergo SAR testing. Co-location with other transmitting antennas closer than
20cm should be avoided.
RF Exposure
The following statement must be included as a CAUTION statement in OEM product
manuals.

IC (Industry Canada) Certification

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.

IC Labeling Requirements

Labeling requirements for Industry Canada are similar to those of the FCC. A clearly visible
label on the outside of the final product enclosure must display the following text.
PRELIMINARY DRAFT
XLR PRO Radio Frequency Module User Guide
WARNING: The FCC requires that all spread spectrum devices operating within the
Unlicensed radio frequency bands must limit themselves to a maximum radiated
power of 4 Watts EIRP. Failure to observe this limit is a violation of our warranty terms,
and shall void the user's authority to operate the equipment. This can be stated as
follows:
RF power - cable loss + antenna gain <= 36 dBm eirp
CAUTION: This equipment is approved for mobile and base station
transmitting devices only. Antenna(s) used for this transmitter must be
installed to provide a separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction with any other
antenna or transmitter.
IC (Industry Canada) Certification
13