Cleaning And Replacing The Air Filter - Christie APS Series Setup Manual

Cleaning and replacing the air filter

Check and clean the air filter periodically. When the indicators or a message
prompts you to clean the air filter, comply with it as soon as possible.
1.
Turn the projector off, and unplug the power cord. Allow the projector to
sufficiently cool down.
2.
Use a vacuum cleaner on and around the filter cover.
3.
Pick and pull up the filter cover knobs to take it off.
4.
Press up slightly the bottom side knobs to unlock the
bottom side of the air filter, and take it off.
5.
Use a vacuum cleaner on both sides of the air filter
while holding it so it will not be sucked in.
If the air filter is damaged or heavily soiled, replace
it with the new one. Request for an air filter with
the following type number from your dealer when
purchasing a new one.
Type number: 003-006612-01
6.
Use a vacuum cleaner for the filter vent of the
projector.
7.
Put back the air filter and filter cover into their place.
8.
Turn the projector on and reset the filter hours using
the FILTER HOURS item in the EASY MENU.
(1) Press the MENU button to display a menu.
(2) Point at the FILTER HOURS using the ▼/▲ buttons, then press the ►
button. A dialog will appear.
(3) Press the ► button to select "OK" on the dialog. It performs resetting the
filter hours.
►Before taking care of the air filter, make sure the power cord is not plugged in,
then allow the projector to cool sufficiently.
LWU650-APS/LWU530-APS
Setup Guide
WARNING
17
Filter cover
2
3
Filter cover knobs
Air filter
4
Air filter knobs
Filter vent
6
(continued on next page)
020-001521-02 Rev. 1 (01-2019)
LIT GUID SET APS Series
5