Appendix C - Control Module Programming; Software Upgrade Instructions - Graco E-Flo DC Series Instructions Manual

Appendix C C C - - - Control
Appendix Appendix
To help prevent fire and explosion, do not
connect, download, or remove the token unless
the unit is removed from the hazardous (explosive
atmosphere) location.
• All All All data data data in in in the the the module module may module
default default default settings. settings. Record all settings and user settings.
preferences before the upgrade, for ease of
restoring them following the upgrade.
• The latest software version for each system can be
found at www.graco.com.
Software Software Upgrade Software Upgrade Instructions Upgrade
NOTE: If the software on the token is the same
NOTE: NOTE:
version that is already programmed on the module,
nothing will happen (including flashing red light).
No harm can be done by attempting to program the
module multiple times.
1. Remove power from the Graco Control Module
by turning off system power.
NOTE: NOTE: Alternately, software update can be done NOTE:
without removing power by using the system
reset button on Setup Screen 16 (date and time)
to initiate the update after token insertion.
2. Remove access cover (C).
3A3453H
Control Module Module Programming
Control Module
may be may be reset be reset to to to factory reset factory factory
Instructions Instructions

Appendix C - Control Module Programming

Programming
Programming
3. Insert and press the token (T) firmly into the slot.
NOTE: NOTE: NOTE: Token has no preferred orientation.
4. Supply electrical power to the Graco Control
Module.
5. The red indicator light (L) will flash while the
software is being loaded on the display. When
the software is completely loaded, the red light
will turn off.
To prevent corrupting the software, do not
remove the token, turn off the system power,
or disconnect any modules until the status
screen indicates that updates are complete.
6. The following screen will be shown when the
display turns on.
Communications with motors established.
7. Wait for update to complete.
NOTE: The approximate time until completion is
shown along bottom of progress bar.
NOTICE
NOTICE NOTICE
73