Fluid Line Accessories; Fill With Oil Before Using Equipment; Flush Before Using Equipment; Control Module Accessory - Graco E-Flo EC1110 Instructions-Parts List Manual

Installation
Fluid Line Line Accessories Accessories
Fluid Fluid Line Accessories
Install the following accessories in the order shown
in Fig. 1, using adapters as necessary. All fluid
lines and accessories must be rated to the maximum
working pressure of 400 psi (2.8 MPa, 28.0 bar).
• Fluid Fluid drain Fluid drain valve drain valve (D): valve (D): required in your system, to (D):
relieve fluid pressure in the hose and circulation
system.
• Fluid Fluid pressure Fluid pressure pressure gauge gauge (E): gauge
adjustment of the fluid pressure.
Fluid shutoff shutoff valve valve (F): (F): shuts off fluid flow.
• Fluid Fluid shutoff valve (F):
Fill With With Oil Oil Before Before Using
Fill Fill With Oil Before
See Fig. 5. Before using the equipment, open the fill
cap (P) and add Graco Part No. 16W645 ISO 220
silicone-free synthetic gear oil. Check the oil level in
the sight glass (K). Fill until the oil level is near the
halfway point of the sight glass. The oil capacity is
approximately 1.5 quarts (1.4 liters). Do
NOTE: Two 1 quart (0.95 liter) bottles of oil are
NOTE: NOTE:
supplied with the equipment.
12
(E): for more precise (E):
Using Equipment Equipment
Using Equipment
Do not Do not overfill. not overfill. overfill.
Figure 5 Sightglass and Oil Fill Cap
Flush Before Before Using Using Equipment
Flush Flush Before Using
The pump fluid section was tested with lightweight
oil, which is left in the fluid passages to protect parts.
To avoid contaminating your fluid with oil, flush the
equipment with a compatible solvent before using
the equipment.
Control Module Module Accessory Accessory
Control Control Module Accessory
The Control Module Accessory is required with
Advanced E-Flo DC motors to provide the interface
for users to enter selections and view information
related to setup and operation. See the Control
Module Accessory Kit manual for installation and
operation information.
Equipment
Equipment
3A2096D