Fluid Line Accessories; Equipment; Flush Before Using The Equipment; Control Module Accessory - Graco E-Flo DC 333389E Instructions - Parts Manual

Fluid Fluid Line Fluid Line Accessories Line Accessories Accessories
Install the following accessories as shown in
Fig. 1, using adapters as necessary. All fluid
lines and accessories must be rated to the
maximum working pressure of the pump. See
Technical Specifications, page
• Fluid Fluid Fluid drain drain valve drain valve (H): valve (H): required in your system, to (H):
relieve fluid pressure in the hose and circulation
system.
• Fluid Fluid pressure Fluid pressure gauge pressure gauge (E): gauge
adjustment of the fluid pressure.
Fluid shutoff shutoff valve valve (F): (F): shuts off fluid flow.
• Fluid Fluid shutoff valve (F):
Check Check the Check the Oil the Oil Level Oil Level Before Level

Equipment

Equipment Equipment
The motor is pre-filled with oil. Before using the
equipment, replace the shipping plug with the vented
fill cap (P) that is included with the motor.
Figure 6 Sightglass and Oil Fill Cap
333389E
35.
(E): for more precise (E):
Before Using Before Using the Using
Flush Before
Flush Flush
The pump fluid section was tested with lightweight
oil, which is left in the fluid passages to protect parts.
To avoid contaminating your fluid with oil, flush the
equipment with a compatible solvent before using
the equipment.
Control Module Control Control
The Control Module Accessory is required with
Advanced E-Flo DC motors to provide the interface
for users to enter selections and view information
related to setup and operation. See the Control
Module Accessory Kit manual for installation and
operation information.
the the
Before Using Using the the Equipment
Before Using the
Module Accessory Module Accessory Accessory
Installation
Equipment
Equipment
13