Grounding; Control Module Accessory; Fluid Line Accessories; Fill With Oil Before Using Equipment - Graco HIP e710 Series Instructions-Parts List Manual

Installation

Grounding

Grounding Grounding
This equipment must be grounded to reduce the
risk of static sparking and electric shock. Electric
or static sparking can cause fumes to ignite or
explode. Improper grounding can cause electric
shock. Grounding provides an escape wire for the
electric current.
1. Connect the supply ground wire in the electrical
compartment as shown in Figs. 3 and 4.
2. Connect a ground wire as shown in Fig. 5.
Loosen the ground screw and attach a ground
wire (Y, Graco part 222011, not supplied).
Tighten the ground screw securely. Connect
the other end of the ground wire to a true earth
ground.
Figure 5 Ground Wire
NOTE: Advanced models require installation NOTE: NOTE:
of a control module. All pumps connected to a
common control module must be grounded to
the same ground point. Different ground points
(unequal potential) may cause current to flow
through component cables, causing incorrect
signals.
Pump
Pump Pump
30H000–003,
EDEN01–04
30H004–007,
EDEN05–08
Fluid hoses: hoses: Use only electrically conductive
3. Fluid Fluid hoses:
hoses with a maximum of 500 ft. (150 m)
combined hose length to ensure grounding
continuity. Check the electrical resistance of
hoses. If total resistance to ground exceeds 25
megohms, replace hose immediately
4. Fluid Fluid supply Fluid supply container: supply container: Follow your local code. container:
10
Control Module Module
Control Control Module
24P822
17V232
Control Module Control Control Module Accessory Module Accessory Accessory
The Control Module Accessory is required with
Advanced E-Flo DC motors to provide the interface
for users to enter selections and view information
related to setup and operation. See the Control
Module Accessory Kit manual for installation and
operation information.
Fluid Line Line Accessories Accessories
Fluid Fluid Line Accessories
Install the following accessories as shown in Fig.
1, using adapters as necessary. All fluid lines and
accessories must be rated to the maximum working
pressure of 400 psi (2.8 MPa, 28.0 bar).
• Fluid Fluid Fluid drain/pressure drain/pressure relief drain/pressure relief valve
your system, to relieve fluid pressure in the hose
and circulation system. Use a valve that is able
to automatically relieve pressure at no more than
130% of your pump's maximum fluid working
pressure. See Technical Specifications, page
• Fluid Fluid Fluid pressure pressure gauge pressure gauge gauge (E):
adjustment of the fluid pressure.
Fluid shutoff shutoff valve valve (F): (F): shuts off fluid flow.
• Fluid Fluid shutoff valve (F):
Fill With With Oil Oil Before Before Using
Fill Fill With Oil Before
See Fig. 5. Before using the equipment, open the fill
cap (P) and add Graco Part No. 16W645 ISO 220
silicone-free synthetic gear oil. Check the oil level in
the sight glass (K). Fill until the oil level is near the
halfway point of the sight glass. The oil capacity is
approximately 1.5 quarts (1.4 liters). Do
NOTE: Two 1 quart (0.95 liter) bottles of oil are
NOTE: NOTE:
supplied with the equipment.
Figure 6 Sightglass and Oil Fill Cap
relief valve (H): valve (H): (H): required in
(E): for more precise (E):
Using Equipment Equipment
Using Equipment
Do not Do not overfill. not overfill. overfill.
3A6358A
25.