Graco E-Flo DC Series Instructions Manual page 43

Setup Screen Screen 19 19
Setup Setup Screen 19
Use this screen to set your date format, date, time,
or force a restart of the system when updating the
software (update token inserted into the display).
After the software update is completed successfully,
the token must be removed prior to selecting the
Acknowledge key or power cycling the display. If an
update was concluded and the token is not removed,
pressing the Acknowledge key restarts the update
process.
NOTE: NOTE: NOTE: Refer to Appendix C - Control Module
Programming, page 73
updating. Software update is disruptive to all pumps
connected to the display. All pumps attached to
the display must not be pumping material when the
software update is initiated.
Figure 59 Setup Screen 19
Setup Screen Screen 19
Setup Setup Screen
Select your preferred date format from
the menu.
• MM/DD/YY
• DD/MM/YY (default)
• YY/MM/DD
Set the correct date.
Set the correct time.
Perform a soft restart of the system.
3A3453H
for instructions on software
19 Key Key
19 Key
Setup Screen Screen 20 20
Setup Setup Screen 20
Use this screen to enter a password that will be
required to access the Setup screens. This screen
also displays the software version.
Figure 60 Setup Screen 20
Setup Setup Setup Screen Screen 20 Screen
When the top box of the screen is
checked, the password is active. To
temporarily disable the password,
uncheck the box. The password field will
be grayed-out.
Enter the desired 4-digit password.
Check the box to lock out the profile field
in the Run screens.
Figure 61 Set the Password
Figure 62 Disable the Password
Figure 63 Lock the Profile
Operation
20 Key 20 Key Key
43