Graco E-Flo DC Series Instructions Manual page 26

Operation
Run Screen Run Run Screen 2 2 2 Screen
This screen displays information for controlling an
electric agitator using the supervisor to pass on
the control set point to a Variable Frequency Drive
(VFD), also known as an inverter.
Figure 8 Run Screen 2
Run Screen Screen 2 2 2 Key
Run Run Screen
Select this box and set the speed
setpoint for the agitator from 0–100%.
Select this box to disable network control
of the agitator and prevent the IPK touch
screen from modifying the Variable
Frequency Drive/Inverter setpoint.
Select this box and hold the softkey to
manually run the pump in the selected
profile. This feature allows the user to
run the motor past the tank level low
alarm to empty the tank.
Select this box and hold the softkey
button to manually control the fill pump
solenoid output.
Current primary tank volume in percent.
The field is populated with data only
when the tank sensor is enabled. See
Setup Screen 14, page
26
Key
Key
40.
Run Screen Run Run Screen 3 3 3 Screen
This screen displays pressure settings for the active
pump and profile.
NOTE: Some fields are grayed out, depending on
NOTE: NOTE:
setup selections.
Figure 9 Run Screen 3
Run Screen Screen 3 3 3 Key
Run Run Screen
Select the profile (1 to 4) from the menu.
Select the stop option
menu to stop the pump.
Displays the target pressure as selected
in Setup Screen 2, page
Figure 10 Run Screen 3, in Pressure Mode
Figure 11 Run Screen 3, in Flow Mode
Key
Key
from the
30.
3A3453H