Run Screens - Graco E-Flo DC Series Instructions Manual

Run Screens

Screens
Run Run Screens
The Run screens display current target values and
performance for a selected profile. Any alarms will
display in the sidebar at the right of the screen.
Screens 6–9 display a log of the last 20 alarms.
Information displayed on the Run screens
corresponds to the Modbus Registers. See
Appendix A - Modbus Variable Map, page
The active profile may be changed in Run Screens
1, 2, and 3.
3A3453H
Run Screen
Run Run
This screen displays information for a selected
profile. A box around an icon indicates which mode
the profile is running (pressure or flow).
60.
Figure 6 Run Screen 1
Figure 7 Select a Profile
Screen 1 1 1
Screen
Run Screen Run Run Screen Screen 1 1 1 Key
Select the profile (1 to 4) from the menu.
Select the stop option
menu to stop the pump.
Displays pump speed in cycles per
minute.
Displays pump pressure as a percentage.
If a transducer is used, this icon is
replaced by the pressure icon.
Displays current flow rate, in units as
selected in Setup Screen 18, page
Operation
Key Key
from the
42.
25