Graco E-Flo DC Series Instructions Manual page 39

Setup Screen Screen 13 13
Setup Setup Screen 13
Use this screen to configure and control the tank fill
feature and Intelligent Paint Kitchen peripherals.
NOTE: The alert trigger time varies based on how far
NOTE: NOTE:
active measurements are from their set limits.
Figure 49 Setup Screen 13
Setup Screen Screen 13
Setup Setup Screen
Select this box to manually activate the
fill solenoid output on port 4, pin 3.
NOTE: NOTE: NOTE: The non-editable box shows the
status of the modbus register.
3A3453H
13 Key Key
13 Key
Select this box to enable the tank to
automatically fill. You can then set the
fill levels.
When the tank level reaches this
level, the fill solenoid turns off.
This value cannot be higher than
the level below.
When the tank level reaches this
level, the fill solenoid turns on.
This value cannot be lower than
the level above.
Configure the low fill pump flow
notification for a deviation or an alarm
and set the time-out value in seconds.
If a 1% level change is not detected
with the timeout period in seconds, the
system takes action based on the event
type.
Operation
39