Screen Navigation And Editing; Initial Setup - Graco E-Flo DC Series Instructions Manual

Screen Navigation Navigation and
Screen Screen Navigation
Refer to this section if you have questions about
screen navigation or about how to enter information
and make selections.
All Screens Screens
All All Screens
1. Use to move between screens.
2. Press to enter a screen. The first data field
on the screen will highlight.
3. Use to highlight the data you wish to
change.
4. Press to edit.
Drop Drop Down Drop Down Field Down Field Field
1. Use to highlight the correct choice from
the dropdown menu.
2. Press to select.
3. Press to cancel.
Number Field Field
Number Number Field
1. The first digit will be highlighted. Use
to change the number.
2. Press to move to the next digit.
3. When all digits are correct, press
accept.
4. Press to cancel.
Check Check Box Check Box Box Field Field Field
A check box field is used to enable or disable features
in the software.
1. Press to toggle between
box.
2. The feature is enabled if a
3A3453H
and Editing Editing
and Editing
again to
and an empty
is in the box.
Reset Reset Field Reset Field Field
The reset field is used for totalizers. Press
reset the field to zero.
When all data is correct, press
Then use to move to a new screen, or
to move between Setup screens and Run screens.

Initial Setup

Setup
Initial Initial Setup
NOTE: Before creating the pump profiles in Setup NOTE: NOTE:
Screens 1 through 4, you must set up the system
parameters in Setup Screens 5 through 14, as
follows.
1. Press to enter the Setup screens. Setup
Screen 1 will appear.
2. Scroll to Setup Screen 5.
3. See Setup Screen 5, page
lower used in your system.
4. Continue setting the system parameters
on Setup Screen 6, page 35
Setup Screen 14, page
5. Scroll to Setup Screen 1. Establish
the profiles for each pump. See
Setup Screen 1, page 28
Setup Screen 4, page
6. When the profiles are set to achieve the desired
pressures and flow rates, start the pump. Go to
Setup Screen 5, page
to perform an automatic system calibration.
The system will learn its optimum settings over
21 cycles.
Operation
to
to exit the screen.
34, and select the
through
40.
through
32.
34. Check the box next to
21