Graco E-Flo DC Series Instructions Manual page 33

Figure 28 Setup Screen 4 (In Flow Mode)
Pressure Mode Mode Examples Examples
Pressure Pressure Mode Examples
Runaway Control: Control: The user may choose to set the
• Runaway Runaway Control:
maximum flow to Alarm. If the flow rate exceeds
the maximum entered on Setup Screen 3, an Alarm
symbol will show on screen and the pump will
shut down.
Detect a a a Plugged Plugged Filter Filter or or or Pipe:
• Detect Detect Plugged Filter
choose to set the minimum flow to Deviation. If
the flow rate drops below the minimum entered on
Setup Screen 3, a Deviation symbol
on screen to warn the user that action should be
taken. The pump continues to run.
3A3453H
Pipe: The user may
Pipe:
will show
Flow Mode Flow Flow Mode Examples Mode Examples Examples
• Runaway Runaway Control: Runaway Control: The user may choose to set Control:
the minimum pressure to Alarm. If a hose bursts,
the pump will not change speed, but the back
pressure will fall. When the pressure falls below
the minimum entered on Setup Screen 2, an Alarm
symbol will show on screen and the pump will
shut down.
• Protect Protect Connected Protect Connected Connected Equipment: Equipment: The user may Equipment:
choose to set the maximum pressure to Limit to
prevent the connected equipment from excessive
pressure.
Detect a a a Plugged Plugged Filter Filter or or or Pipe:
• Detect Detect Plugged Filter
choose to set the maximum pressure to Deviation.
When the pressure exceeds the maximum entered
on Setup Screen 2, a Deviation symbol
show on screen to warn the user that action should
be taken. The pump continues to run.
Operation
Pipe: The user may
Pipe:
will
33