Graco E-Flo DC Series Instructions Manual page 31

Setup Screen Screen 3 3 3
Setup Setup Screen
Use this screen to set your flow rate settings for a
selected profile. In pressure mode, you will set a
maximum flow rate. In flow mode, you will set a target
flow rate. In either pressure or flow mode, a minimum
flow rate may be set if desired. See Setup Screen 4
to specify how the system will respond if the pump
begins to operate outside of the set boundaries.
Figure 22 Setup Screen 3
Setup Setup Screen Setup
Profile selection — See Step 2.
Flow rate maximum — See Step 3.
Flow rate target — See Step 4.
In pressure mode, set the maximum flow
rate. The software calculates the number
of pump cycles needed to achieve that
flow rate. This field is not used in flow
mode.
NOTE: If the profile does not have a
maximum flow rate setting, the motor will
not run and error code WSC_ appears.
Flow rate minimum — See Step 5.
This softkey is disabled by default, and
only appears if the Profile
checked on
Press to activate the profile just edited.
3A3453H
Screen 3 3 3 Key Screen Key Key
Profile Lock Profile Lock box is Lock
Setup Screen 20, page
1. Select the desired profile (1 to 4), using the
pull-down menu.
2. In In In flow
not used in pressure mode.
Figure 23 Flow Mode: Flow Rate Settings
3. In In In pressure
The software will calculate the number of pump
cycles needed to achieve that flow rate. This field
is not used in flow mode.
NOTE: NOTE: The motor will not run if the profile does NOTE:
not have a maximum flow rate setting.
Figure 24 Pressure Mode: Flow Rate Settings
4. If desired, set a minimum flow rate.
43.
flow mode, mode, set a target flow rate. This field is
flow mode,
pressure mode, mode, set the maximum flow rate.
pressure mode,
Operation
31