Motor Control Module (Mcm) - Graco VPM Series Instructions Manual

Component Identification

Motor Control Module (MCM)

NOTICE
If the Motor Control Module is replaced, the selec-
tor switch must be set prior to initial startup of the
Motor Control Module or damage may occur. See
Adjust Motor Control Module Selector Switch
on page 27.
A
C
12
F . 6: MCM Component Identification
IG
16
B
1A
10
The MCM is located in the Hydraulic Power Pack.
When installed, the end of the MCM with the power
input connection (12) faces down and the end with the
access cover (A) faces up.
The Motor Control Module uses an 8-position selector
switch to set the system maximum working pressure.
3
2
1B
5
r_257396_3b9905_01b
6
8
7
13
r_257396_3b9905_03b
9
11
313875J