To Run The Self Tests; To Exit The Test System - Keysight Technologies U4164A Service Manual

5 Troubleshooting

To run the self tests

You can run self tests on the U4164A module to verify if the module is operating correctly. Before
running self tests, ensure that:
•
•
•
You use the Analysis System Self Tests window to run self tests. Refer to the topic
Self-Tests"
If all tests did not pass, refer to

To exit the test system

Close the self-test window. No additional actions are required.
58
you have connected all the hardware components for the U4164A module
created a logical module for U4164A in the Keysight Logic Analyzer application.
disconnected all probes from the logic analyzer module.
on page 21 to know how to run these tests.
"To use the flowcharts" on page 54.
"Perform the
Keysight U4164A Logic Analyzer Service Guide