Circuit Board Code - Bosch Rexroth IndraDrive MPH-02 Functional Description

10-18
Handling, Diagnostic and Service Functions

Circuit Board Code

Brief Description
The configurable control section of a drive controller consists of the basic
control section circuit board and one or several optional modules (see
type code in the documentation "Project Planning Manual for Control
Section").
An individual parameter is assigned to each slot for circuit board or
optional module (cf. P-0-1506 to P-0-1511). The specific data (circuit
board code) of the circuit board that has been plugged are stored in these
parameters.
Note: The circuit board codes are stored directly on the circuit board
or the respective optional module.
basic circuit board
control section
P-0-1511
control section
P-0-1520
circuit board
power section
P-0-1510
power section
drive controller
S-0-0140
S-0-0140: controller type
P-0-1506: circuit board code optional module 1
P-0-1507: circuit board code optional module 2
P-0-1508: circuit board code optional module 3
P-0-1509: circuit board code master communication
P-0-1510: circuit board code power section
P-0-1511: circuit board code control section
P-0-1520: control section type
Fig. 10-4: Device configuration and circuit board code for IndraDrive
In the initialization phase (when booting), the drive firmware automatically
checks the arrangement (configuration) of the control section by means of
the individual circuit board codes and on this basis generates the content
of parameter P-0-1520, Control section type. The configuration of the
control section used can be read via this parameter.
MPH-02, MPB-02, MPD-02
optional module
optional module 1
communication
P-0-1506
optional module 2
P-0-1507
optional module 3
P-0-1508
DOK-INDRV*-MP*-02VRS**-FK01-EN-P
master
P-0-1509
DF0063v1.fh7