Cutting Unit Maintenance; Backlapping The Cutting Units - Toro Reelmaster 7000-D Operator's Manual
4-wheel drive traction unit
Hide thumbs
Also See for Reelmaster 7000-D:
- Service manual (468 pages) ,
- Operator's manual (144 pages) ,
- Installation instructions (2 pages)
Table of Contents
Advertisement
Cutting Unit Maintenance
Backlapping the Cutting Units
Contact with the cutting units or other moving parts could result in death or serious
injury.
• Keep your fingers, hands, and clothing away from the cutting units and other
moving parts.
• Never attempt to turn the cutting units by hand or foot while the engine is running.
Note:
Additional instructions and procedures on backlapping are available in the Toro
Sharpening Reel and Rotary Mowers Manual, Form No. 80-300SL.
Preparing the Machine
1. Park the machine on a level surface, lower the cutting units, engage the parking brake,
shut off the engine, and move the PTO switch to the D
2. Open the hood.
3. Make initial reel-to-bedknife adjustments appropriate for backlapping on all cutting units
which are to be backlapped; refer to the cutting unit Operator's Manual.
4. Rotate the front, rear, or both backlap levers to the R (backlap) position.
Maintenance: Cutting Unit Maintenance
WARNING
G425458
Page 6–46
position.
ISENGAGE
3466-706 A
Advertisement
Table of Contents
