Backlapping the Cutting Units
Contact with the cutting units or other moving parts could result in death or serious
injury.
• Keep your fingers, hands, and clothing away from the cutting units and other
moving parts.
• Never attempt to turn the cutting units by hand or foot while the engine is running.
Note:
Additional instructions and procedures on backlapping are available in the Toro Reel
Mower Basics (with sharpening guidelines), Form 09168SL.
Preparing the Machine
1. Prepare the machine for maintenance.
2. Make the initial reel-to-bedknife adjustments appropriate for backlapping; refer to the
cutting unit Operator's Manual.
3. Lift the magnetically mounted console cover to expose the mower manifold.
4. Move the backlap lever to the R (backlap) position.
Maintenance: Cutting Unit Maintenance
WARNING
G353458s
G417036
Page 6–34
Backlap control
Reel speed control
3466-297 A